Industrial LuNAR DT AM Grade 3 Installation Guide
11
NOTE:
When a single gang box is used, use 2 additional
screws to mount the base to the single gang box.
The back tamper cannot be used in this case!
Return the PCB to its previous location and verify that it is well secured by the holding clips and
the screw.
Perform lens adjustment and DIP switch settings as described in
“
Lens Adjustment
”
on page 11
and on page 14.
Mount the top cover on the detector
’
s base.
Tighten the top cover
’
s central screw.
Replace the detector
’
s protection cap.
NOTE:
For a ceiling tamper, affix the back tamper screw as
shown in Figure 5.
Lens Adjustment:
The Ind. LuNAR 200DTG3
has three - Fresnel lenses attached to the cover, located in sensor
protective sleeves. Adjust the position of the lenses based on the ceiling mounting height as
follows:
Press the 2 clips attaching the sleeve
(Figure 6)
to the detector
’
s cover, and gently pull out the
sleeve.
FIGURE -5
FIGURE 5
