Page 7
Re-setting the system.
1) If the system is programmed for Any code reset, enter a
User
code.
The display will show:-
Note:
If NO is NOT pressed then the alarm status will only be displayed for ten seconds.
2) The display will then show:- Enter your user code again.
3) The display will show:-
To return to the ‘ALARM’ display, press 0 then NO to view the cause
.
4) Press YES. The exit tone will sound, and the display will show, for example:-
5) Enter the code again to abort the setting.
6) The system is now reset
Or
If a higher level of code is required one of the following displays will be shown:-
Use a
Master
code to reset the system.
Or:-
Call the installation company
Or:-
Call the central station or installation company (as instructed) and quote the number given
Or:-
7) To reset the system with an
Anti-Code
, contact the central station or engineer (as instructed by the
installation company) and quote the number given by the display.
8) The central station or engineer will give a return Anti-Code, (this may contain the YES & NO keys) for
example 5, YES, 2, 4.
9) Enter this Anti-Code into the keypad.
10) The system is now reset.
Note:
A full and comprehensive User Manual can be downloaded from
www.riscogroup.com/uk
Can't Set ! use . .
Master
Can't Set ! use . . Eng.
Code
Can't Set ! use . . Eng.
+Anti Code 1234
Can't Set ! use . . Anti
Code 1234
15
EXIT! 1
All Zones ON
<<<< ALARM >>>>
Press NO to view
! ! Enter Code ! !
! ! ! ! Check ! ! ! !
Do you want to . .
SET the System ?
