4
INTRODUCTION
INTRODUCTION
INTRODUCTION
INTRODUCTION
The 2-Way keypad is used to remotely program and operate the Agility security
system. Being bi-directional the 2-Way keypad receives a reply status indication from
the panel for each command that it has sent to the panel. To use functions of the
keypad you can use a code or a proximity tag.
COMMUNICATION SETUP
COMMUNICATION SETUP
COMMUNICATION SETUP
COMMUNICATION SETUP
The Keypad is automatically programmed to your control panel during the on-line
installation wizard setup. If you later purchase an extra keypad you can enroll it as
follows:
To quickly allocate a keypad at the control panel:
If the control panel is not already in Learn mode, press the
button on the control
panel for 5 seconds; the unit beeps once as it enters Learn mode (all the LEDs also light
up, one after the other).
Make sure batteries are installed in each keypad before allocating them.
Send a signal transmission from the keypad by pressing
and
simultaneously for at least 2 seconds; the control panel beeps once to accept or beeps
three times to reject. Once accepted, the system announces the device type and its zone
(for example, “Keypad, zone 1”).
When the keypads have been enrolled, short-press the control panel button
to
exit Learn mode; the unit beeps once and the LEDs stop flashing.
Note:.
Note
:
For future use, it is recommended to write down the keypad description, zone number, and
installation location of each allocated keypad.
