25 |
P a g e
8.
Prepare an 11/64” drill bit to drill a pilot hole for 3/8” X 3” Lag Screws. Wrap tape around the drill bit shaft 3” from the
end of the drill bit. While drilling the pilot hole, the tape edge will indicate when you have reached the required depth.
9.
Locate two 7/16” holes on the decorated face of the post top dual header bracket. Drill an 11/64
th
X 3” deep pilot hole
in the center of each 7/16” hole. The pilot hole will go through the header and into the 4x4 post. Drill at least 3” deep or
a little bit deeper, not shallower.
TWO HOLES ON
THIS SIDE ALSO
