Rion Grand Gardener, Assembly Instructions Manual

Page: 3 / 81

SAFETY ADVICE
•
Rion is not responsible for the misuse of tools or parts.
•
It is of utmost importance to assemble all of the parts according to the directions. Please follow them closely and
do not skip any step.
•
We strongly recommend using work gloves during assembly.
•
If using a step ladder or power tools ensure that you follow the manufacturer’s safety advice.
•
If local building codes require permits or licenses make sure that they are acquired before beginning.
•
Your Greenhouse should be secure by anchored to the prepared foundation using the recommended hardware.
•
Do not attempt to assemble the greenhouse in windy or wet conditions.
•
Dispose of all plastic bags safely keep them out of reach of small children.
•
Keep children away from the assembly area.
•
Do not lean against or push the greenhouse during construction.
•
Do not attempt to assemble this greenhouse if you are tired, have taken drugs or alcohol or if you are prone to
dizzy spell.
•
Hot items such as recently used grills, blowtorches etc. must not be stored in the greenhouse. Ensure there are no
hidden pipes or cables in the ground before inserting the pegs.
•
When your Greenhouse is fully assembled examine it for sharp edges and trim with a razor knife if necessary.
•
If you live in a hot climate, where outside temperatures exceed 46° C (115° F) in the sun or 36° C (99° F) in the
shade, this may cause the temperature inside the greenhouse to exceed 55° C (131° F). Such conditions may harm
your plants and will damage the greenhouse by warping structural profiles. In order to prevent damage:
BEFORE ASSEMBLY
•
Rion is not responsible for the misuse of tools or parts.
•
Selecting a site - the greenhouse must be, positioned and fixed on a flat level surface.
•
Sort the parts and check according to the contents parts list. Do not begin assembly if any parts are missing.
•
If you prepare a concrete foundation do not excavate and pour concrete in frozen ground.
•
We recommend that you place your Greenhouse in a spot where it will receive direct sunlight and will be
protected from the wind as much as possible. The door should not face prevailing winds.
DURING ASSEMBLY
Steps 2-5:
Arrange all 2D connectors with the stamped word OUT facing the outside of the greenhouse.
Step 6:
•
Make sure that the frame is perfectly rectilinear by measuring the diagonals and verifying that they are the same.
•
Make sure that the frame is level and anchor it with screw / screw + dibble / spike (not included) according to the
selected surface.
Step 10:
Walls assembly must be made gradually (1.panel 2.rofile 3.connector) according to describe method in
steps 9
.
Step 17:
Walls assembly must be made gradually (1.panel 2.rofile 3.connector) according to describe method in
previous
step 16
Step 67:
Insert the rubber strip from the inside
the greenhouse. Applicable on panels
PP1 + PN126 and cut the remaining edges
as needed.
REQUIRED TOOLS
•
GT1 - Special tool to connect pins through lined up holes. Pin Tool fix and lock profiles in place
•
To assemble this product you will need the following tools (these items not supplied)
•
Ensure good ventilation during hot days.
•
Make sure that the temperature inside the green house never exceeds 55° C (131° F) by providing a shading
screen, such as the Shade Net (available as an accessories option).
Note:
RION is not responsible for any damage due to high temperatures.
* Always close roof vent in high winds.
x2
¼”
7 mm 10 mm
When encountering the information icon, please refer to the
relevant assembly step for additional comments and assistance.
This icon indicates that the installer should be inside the product.
Attention: