pTR
Press and hold the “
▲
“ button; the minutes will begin to change first, then the time will change by whole
hours.
Release the button when AM 10:00 shows on the Digital Display. Confirm that you have selected AM, a small
indicator on the left hand side of the Digital Display indicates the AM setting.
Press and hold the “
▲
“ button again, release the button when AM 10:35 shows. If you go past AM 10:35, then
the “
▼
“ button can be used to change the time settings in reverse.
Press the Timer Set button five times to lock in and complete setting the time. The Clock and Timer indicators
will go out. A small indicator on the Digital Display will flash to show that the clock is operating.
•
SETTING THE CLOCK
When the appliance is first plugged in or after a power failure, the Digital Display will show
--
:
--
As an example, let’s set the clock to 10:35 am:
Press the SET TIMES button once, the Clock indicator will flash.
As an example, let’s program Timer 1 to heat the room by 7:10am and finish at 9:00am.
Press the Set Times button twice. The Digital Display will show AM 6:00. Timer 1 indicator will flash.
Press the “
▲
“ button until AM 7:00 appears, release the button, then press it again until AM 7:10 appears.
(Press the “
▼
“ button if you go past AM 7:10.)
Press the Set Times button again, the Timer 1 OFF indicator will flash. Press the “
▲
“ button until AM 9:00
appears. (Press the “
▼
“ button if you go past AM 9:00.)
Press the Set Times button three times to lock in the program time. The Digital Display will show the current
time. A small indicator on the Digital Display will flash to show that the Display has returned to the clock.
Before programming the Timers you must ensure that the clock has been set to the correct time.
Timer 2 is programmed in the same way, remember to ensure that the Timer 2 indicator is flashing
when you program in the desired setting. The Timers can be programmed to operate for any two
periods in any 24 hours.
Turn to the next page to operate the dual timer. The programmed time must be selected and
locked-in within one minute of the On Timer indicators flashing otherwise the programmed times will
not be retained in the system memory.
•
PROGRAMMING THE ON / OFF TIMERS
SETTING THE CLOCK
5
Summary of Contents for Royale ETR Freestanding
Page 15: ...WIRING DIAGRAM 15 ...
