1. Ignition
1) Push ON/OFF button fully. (Fig. 3)
2) Electronic spark will ignite burner.
3) Keep pushing the button for a few seconds, safety
device will then operate.
4) Release the button and ensure that burner is alight.
5) Repeat the same procedures if burner fails to be
ignited.
2. Flame Control (Fig. 4)
You can adjust the flame by shifting the Flame Con-
troller toward left and right slowly.
If you want to change flame from “High” to “Low”,
slide and lift the lug toward right.
3. To turn off (Fig. 5)
Push ON/OFF button to extinguish the flame.
Button returns to OFF position.
Note:
✻
The Safety Sensor is delicate, please do not use stiff
brushes or rough cleaning pads when cleaning.
✻
Aeration is preset at manufacturing, please do not at-
tempt to adjust it.
✻
Please do not use Aluminum mat. Use of aluminum
mat may cause combustion problem.
HANDLING CONDITIONS WHEN SAFETY DEVICE OPERATES
If the flame is extinguished during operation, the automatic Flame Failure Safety Device will shut the gas off after
a short delay.
If you notice that the flame has been extinguished, please push the ON/OFF button to the OFF position.
CHANGE BATTERY
✻
Change battery when sparking becomes slow (2–3 sparks per second).
✻
Battery Case is located at left hand side of the front control panel. (Fig. 6)
1. Open battery case cover.
2. Replace battery with correct polarity.
3. Close battery case cover.
DIRECTIONS FOR USE
Display Window (Red)
Fig. 3
High flame
Low flame
Display Window
(Red disappear)
Fig. 4
Fig. 5
Fig. 6
➀
➁
Handle
Battery
