Rinnai RHFE-1510F Operating And Installation Instructions Download Page 2

Warranty

e

Installation Instructions

must be used

e

 3

 4

As the purchaser of this high quality Rinnai Space Heater you are provided with 
the following conditional warranty.

Heat Exchanger:        5 years*
All other Parts:           1 year
Labour:                      1 year

*Full Heat Exchanger replacement (parts only) in the first five years, thereafter 
reducing as follows, subject to conformity.  A replacement heat exchanger will be 
supplied at the normal selling price less the following discounts.

Year 6:   80% discount
Year 7:   60% discount
Year 8:   40% discount
Year 9:   20% discount
Year 10: 10% discount

This warranty does not cover cleaning and normal wear and tear, calls of this 
nature may be chargeable.  Please check the troubleshooting chart on page 29 
before asking for a service call. You may be able to overcome the problem, or 
the heater may be operating normally. Service calls to a heater that is operating 
normally may be chargeable, even if the heater is under warranty.

The installer is responsible for the heater's correct installation.

CONDITIONS

1.  It is a condition of this warranty that the heater shall have been serviced 
annually during its lifetime by a suitably qualified engineer, and that it must have 
been installed and used in accordance with these instructions.
2.  Failing to use genuine Rinnai spare parts, or attempting to repair the 
appliance yourself may invalidate the warranty.
3.  The serial number of the heater must be supplied prior to any claim being 
processed.

IMPORTANT INFORMATION

1. Gas safety (Installation & Use) regulations 1998 are the ‘Rules in force’. In your own 
interest and that of safety, it is law that all gas appliances are installed by competent 
persons in accordance with the above regulations. Failure to install appliances correctly 
could lead to prosecution. Other persons should NOT attempt to install this equipment.

2. Unpack the appliance and check it carefully. If it appears to have any defects or 
damage DO NOT INSTALL, contact your supplier.

3. The heater is intended to be used to raise the temperature in a room or office, etc. Do 
not use it for any other purpose without consulting Rinnai UK.

4.  This appliance is safe if correctly installed and sited. Please comply carefully with these 
instructions.

5.  This appliance is to be used with Natural Gas (G20) or Propane (G31) only.  The data 
plate on the side of the unit will show which gas it is set up for.

6

. Installation must be carried out in accordance with the current issue of the following:

•Building regulations issued by the Department of the Environment and Building 
Standards (Scotland) Regulations.
•I.E.E. Wiring regulations for electrical installations.
•Gas safety (Installation and Use) Regulations current issue.
•BS 5871 part 1:2001
•BS 5440 part 1 and 2
•BS 6891
•BS 5482
•Local byelaws
•Health and safety at work etc. Act 1974
•Children and Young persons act 1933, revised 1952

•Such other specifications and regulations that may supersede or complement the above 
documents.

Summary of Contents for RHFE-1510F



















Reviews: