– 3 –
* If another built-in appliance (e.g. dishwasher, washer, etc,) is to be installed under the built-in hob, keep a
clearance of at least 10mm from the bottom of the built-in hob. If the installation of the appliance underneath
requires a different distance, adopt the larger value.
若在嵌入式平面爐下安裝其他器具 ( 如洗碗碟機 , 洗衣機等 )
。 請保留最少
10
毫米的距離。
若其他器具的安裝指引要求不同的間距 , 應採用較大者。
* The built-in hob should be installed with a distance of more than 15cm away from surrounding combustible
materials.
此爐具的安裝位置應與週圍易燃物料距離
15
厘米以上。
* If the built-in hob is to be installed on top of a built-in oven, a partition between two appliances is required
with all gaps being sealed. It is to avoid the infl uence of air draught on the operation of the built-in hob when
the oven fan is running.
煮食爐下方如設有嵌入式焗爐 , 必須加裝隔層板並將所有縫隙密封 , 避免焗爐的風機氣流影響煮食
爐運作。
* In case putting partition plate under appliance, stand apart from appliance by over 10cm.
若要將隔層板安裝在器具下，站架需與器具隔開
10
釐米以上。
* Make sure that the following parts are fi tted properly before use:
使用前請確定以下配件已置於正確位置 :
1. Pan Support
爐架
Fit Pan Support into Glass Top Plate.
爐架正確地安放於玻璃面板上。
Install the hollow part behind the trivet nail
part at the two points of convex side of the top
plate properly.
將凹入部分穩當地安裝在頂面板凸面上的
兩點的三腳火爐架尖頭部分後
2. Burner Head, Burner Body
爐頭 , 爐體
Set back holes of Burner Body with Electrode Fixing place. Then insert Burner Head Pin to top holes of
Burner Body.
將爐體後的開孔對準點火針安裝位置。然後將爐頭腳插入爐體面上的插孔。
Fit Burner Head into Burner Body properly without gap. See the right illustration as below.
爐頭放置在爐體上 ,
放置時請勿傾斜。 如下圖。
Burner Head-S
爐頭 -
S
Spark Electrode
點火針
Burner Head-H
爐頭 -
H
Safety Sensor
安全感應頭
Pan Support Depression
爐架凹部
Drip Pan Projection
爐碟凸部
Gap
空隙
Gap
空隙
RB-11S-C(NEW).indd Sec1:3
RB-11S-C(NEW).indd Sec1:3
3/18/2009 2:55:51 PM
3/18/2009 2:55:51 PM