Rinnai INFINITY 26i, Service Manual

Page: 6 / 20

6
Rinnai water heaters will NEVER RUN OUT of hot water. As long as electricity, water, and gas
supplies are connected, hot water is available when hot water taps are open.
Built into the main micro-processor is the facility to LIMIT THE MAXIMUM TEMPERATURE of the hot
water supplied. The water temperature may be set to various temperatures. This is particularly useful
when the hot water unit is installed where young children or the infirm may be using the hot water. If
required, the temperature can be changed via the dip switches on the PCB or with a localised
controller. For further information, please contact Rinnai.
Rinnai water heaters are powered flue appliances. This makes them COMPACT, saving both floor
and wall space.
The temperature of outgoing hot water is CONSTANTLY MONITORED by a BUILT-IN SENSOR. If
the temperature of the outgoing hot water rises to more than 3°C above the selected temperature the
burner is shut OFF and only turned ON again when the temperature falls to below the selected
temperature.
The burner lights automatically when the hot water tap is opened, and extinguishes when the tap is
closed. IGNITION IS ELECTRONIC, so there is no pilot light. When the hot water tap is off, no gas is
used.
Up to four external temperature controllers can be mounted remotely from the heater. One Standard
control is supplied with all appliances (except for HD range). The remote offers the following
additional features:
Localised temperature setting
Diagnostic information
Error Codes
‘Deluxe’ Temperature Controllers are an optional extra. These provide functions including Bath Fill,
Voice Prompt, and Clock Setting.
Temperatures selected at the controllers are retained in the SYSTEM MEMORY.
Operating NOISE LEVEL IS VERY LOW.
ERROR MESSAGES ARE DISPLAYED on the Temperature Controllers and Status Monitor,
assisting with service.
FROST PROTECTION device built in as standard providing a power supply is maintained
FEATURES AND BENEFITS