Rinnai
25
HW_CF OIM
Location
NOTE
•
DO NOT
install water controllers near a heat source, such as a cook top, stove or oven. Heat,
steam, smoke and hot oil may cause damage.
•
DO NOT
install water controllers outdoors unless protection from water / dust ingress and
sunlight are provided.
• The water controller set as the
MASTER
water controller
MUST NOT
be installed in a
bathroom.
•
DO NOT
install water controllers in direct sunlight.
•
DO NOT
install water controllers against a metal wall unless the wall is earthed in accordance
• Water controllers
MUST NOT
be installed where chemicals such as benzene, alcohol,
turpentine, hydrogen sulphide, ammonia, chlorine or other similar chemicals are in use.
The Water controller is a water resistant device, however excessive exposure to water may result
in damage to the water controller. Durability is improved when positioned outside the shower
recess.
•
AVOID
direct exposure to water or steam as these conditions may cause a malfunction.
•
MUST BE
installed at least 400 mm above the highest part of a sink, basin or bath.
• When cleaning your water controller use
ONLY
a damp cloth and a mild detergent.
For water controller dimensions refer to "Table 4. Appliance Dimensions - B Series & Universal
Water Controller" on page 34.
Communication Cables
Wired water controllers operate at an extra low voltage (12 Volts DC) which is supplied from the water heater,
a 10 metre long communications cable is supplied for connection to the water heater.
Rinnai supplied
communication cables may be used.
Optional longer per metre communication cabling Part No. 92078609 is available from Rinnai.
NOTE
The per metre communication cable does not come supplied with spade connectors, spade
connectors are available from your local electrical component retailer.
Joining Communication Cables (REU-A / REU-AM)
A
so
that there are only two sets of spade connectors (4 spade connectors in total) to be terminated (spade connectors
are available from your local electrical component retailer).
Follow steps 1 through 5 of "Connecting Communication Cable(s) With 'Ezi connect' (REU-A / REU-AM)" on page
26 to terminate the joined cable pairs to the water heater.
When
Terminating
Three Cables
When
Terminating
Four Cables
A
A
A