Comple
9
TESTING & COMMISSIONING
TESTING PROCEDURE
Turn gas supply on and plug the unit into the power supply. (Caution 240V.)
•
TO CHECK BURNER PRESSURE
•
Refer to Data Plate.
•
Remove test point screw and attach manometer to test point.
The test point is on the front side of the gas valve.
Light heater, push control buttons to the high position and
check pressure.
•
If adjustments are necessary, the regulator is situated on
the front of the gas control.
•
After checking pressure, turn the unit off, remove manometer and replace test point screw.
•
Turn the heater on and off a few times to check ignition.
•
When you are satisfi ed that the heater is working correctly, reassemble panels.
•
All burner aeration is factory preset and cannot be adjusted.
•
If you are unable to get the unit to operate correctly, refer to Troubleshooting on Page 5,
before contacting your local service agent as listed on Page 10.
•
It may take approximately 2 hours for the logs to achieve their full fl ame pattern and glow.
•
During the initial burning in period, some smoke and smell may be experienced. The
heater should be run on the high position in a well ventilated room until these dissipate.
•
INSTRUCT CUSTOMER ON USE OF UNIT
Explain to customer about use and care of unit. Make sure the customer understands the instructions.
•
EXPLAIN
Ignition, Adjusting heat level, Fan Switch, Turning “OFF”.
COMMISSIONING
•
INSTALLATION AND COMMISSIONING CHECKLIST
Complete the installation / commissioning checklist and the installer / gasfi tter details on page 12 and
make sure that this instruction book is left with the customer.
NOTE:
RINNAI RESERVES THE RIGHT TO CHANGE OR MODIFY SPECIFICATIONS WITHOUT NOTICE.
Summary of Contents for FS 35
Page 11: ......
