Rinnai FM10LA, Operation & Installation Manual, Page: 14 / 24

Rinnai 14 HW_GI_FM10 OIM
APPLIANCE MOUNTING METHOD
1. After determining the desired location for the water heater, use the
dimensions in the drawing right to measure and mark off the positions of the
3 appliance mounting points
A
and the 4 heat shield mounting points
B
.
2. Install 3 suitable screws or bolts at the 3 appliance mounting points
A
.
IMPORTANT
1mm
Ensure to leave at least a 1mm gap between the
inner face of the fixing and the wall. This gap is
necessary as it will facilitate the correct mounting
of the water heater in step 4.
3. Using suitable fixings secure the heat shield flush onto the wall at the 4 heat
shield mounting points
B
.
IMPORTANT This Way Up!
The heat shield is to be mounted
with the more rounded corners
facing upwards and with the folded
tabs facing the walls surface.
4. Using the keyed mounts points, hang the water heater onto the 3 appliance
mounting fixings installed in step 2. Ensuring that all 3 mounting points are
securely engaged.
SERVICE CONNECTION POINTS
NOTE
See Table 1, (Specification table) for individual
appliance connection / fitting dimensions.
These dimensions are NOT an indication of the
pipe sizes required.
•
An approved full flow isolation valve and disconnection
union MUST be fitted to the cold water inlet.
•
A non return valve is not required unless required by local
regulations. Isolation valves MUST NOT be fitted directly
to the appliance.
•
Purge gas and cold water supply lines to remove air and
swarf before final connection of the appliance. Swarf in
either the gas or water supplies may cause damage or
malfunction. These are not covered by warranty.
4.
2.
A
CL
3.
CL
B
Propane Gas
1
2
3
Natural Gas
1
2
4
1
2
3
½’ Gas Adaptor with washer (supplied)
Gas Regulator (supplied)
½’ to ½’ Regulator inlet pressure test point (supplied)
4
¾’ to ½’ Regulator inlet pressure test point (supplied)
425
185
140
157.5
315
120
240
A
A
A
B B
GENERAL INSTALLATION INFORMATION