Rinnai FC510, Installation And Operation Manual

Page: 11 / 44

Fan Convector Manual 11
Consumer Operation Guidelines for the Safe Operation of your Fan Convection Heater
FOR YOUR SAFETY READ BEFORE OPERATING
A. This appliance does not have a pilot. It is
equipped with an ignition device that
automatically lights the burner.
Do not try to light
the burner by hand.
B. BEFORE OPERATING smell all around the appliance
area for gas. Be sure to smell next to the floor
because some gas is heavier than air and will
settle on the floor.
WHAT TO DO IF YOU SMELL GAS

Do not try to light any appliance.

Do not touch any electric switch; do not use any
phone in your building.

Immediately call your gas supplier from a
neighbor’s phone. Follow the gas supplier’s
instructions.

If you cannot reach your gas supplier, call the fire
department.
C. Do not use this appliance if any part has been
under water. Immediately call a licensed
professional to inspect the appliance and to
replace any part of the control system and any gas
control which has been under water.
TO TURN OFF GAS TO APPLIANCE
1. Turn off all electric power to the appliance using
the ON/OFF button.
2. Turn the manual valve clockwise to the full
OFF position.
Due to the high surface temperature, keep children,
clothing and furniture away. Keep burner and control
compartment clean. See installation and operating
instructions accompanying heater.
WARNING: Improper installation, adjustment,
alteration, service, or maintenance can cause personal
injury or loss of life. Refer to owner’s manual provided
with appliance. Installation and service must be
performed by a qualified installer, service agency , or
the gas supplier.
OPERATING INSTRUCTIONS
STOP! Read the safety information above.
1. Turn off all electric power to the appliance using
the ON/OFF button on the control panel.
3. This appliance is equipped with an ignition device
that automatically lights the burner. Do not try to
light the burner by hand.
4. Locate the manual gas valve on the back side of
the heater. Turn the manual valve clockwise
to the full OFF position.
5. Wait five (5) minutes to clear out any gas. Then
smell for gas, including near the floor. If you smell
gas, STOP! Follow “B” in the safety information
above. If you don’t smell gas, go to the next step.
6. Turn the manual gas valve counterclockwise
to the full ON position.
7. Turn on all electric power to the appliance using
the ON/OFF button.
8. Set the thermostat to desired setting.
9. Burner is lit when operation lamp glows red.
10. If operation lamp is flashing red,
burner has not been lit and an error
code will display.
11. If the appliance will not operate, follow the
instructions “To turn off gas appliance” and call
your licensed service technician or gas supplier.
WARNING If you do not follow these instructions exactly, a fire or explosion
may result causing property damage, personal injury or loss of life.