A
S
S
E
M
B
L
Y
11
11
TEST FOR LEAKS WITH A
SOAP SOLUTION, NEVER WITH AN
OPEN FLAME (Refer pages 3 and 4) .
CONNECTING TO, AND DISCONNECTING
FROM GAS SOURCE
2.
Attach cylinder connection
device of regulator and hose
assembly to cylinder
valve outlet.
Tighten firmly.
3.
Open the gas
cylinder valve
fully to allow gas to flow.
4.
Leak test all accessible
connections thoroughly
using a soapy water
solution prior to lighting
the barbecue.
Refer to Safety information, pages 3.
5.
If a leak is found, turn gas cylinder valve off and do
not use barbecue until repairs or replacement can
be made.
DISCONNECTING FROM GAS SOURCE
1.
Turn the burner control
‘OFF’
.
2.
Turn the gas cylinder valve off fully.
3.
Detach the regulator assembly from gas cylinder
valve.
CONNECTING TO GAS SOURCE
1.
Place the gas cylinder into
the gas cylinder
housing
‘A’
and face
the gas cylinder
valve to the
right rear corner.
Secure with the
wing bolt.
CAUTION: When the appliance is not in use, the
gas must be turned off at the gas cylinder.
This barbecue is also certified for use on natural gas.
Contact your place of purchase for advice in relation to
using your barbecue on natural gas.
Refer to back cover
for contact details.
Barbecues for use on natural gas must be installed
by an authorised person.
NATURAL GAS INSTALLATION
IMPORTANT: Before connecting and disconnecting
barbecue to gas source, ensure burner controls are in
‘OFF’ position.
NOTE: The ‘OFF’ position on the control panel is
identified by either a small black dot / a short vertical
black line / or the word ‘OFF’.
When the marking, or the word ‘OFF’ printed on
the control knob, aligns with the printed marking on the
control panel, then the burner is in the fully off position.
CAUTION: When the appliance is not in use, the gas
must be turned off at the gas cylinder
.
Familiarise yourself with the general information and
safety guidelines located at the front of this booklet.
Check to see that gas cylinder is filled and that end of
each burner tube is properly located over each valve
orifice. Set burner controls to
‘OFF’
position.
ENSURING BURNER CONTROLS ARE OFF
• DISCONNECT AND REMOVE GAS
CYLINDER WHEN MANOEUVRING THE
BARBECUE OVER UNEVEN SURFACES
OR CARRYING UP AND DOWN STAIRS
• IF THIS INFORMATION IS NOT
FOLLOWED EXACTLY, A FIRE
CAUSING DEATH OR SERIOUS INJURY
MAY OCCUR!
• DO NOT STORE A SPARE GAS
CYLINDER UNDER OR NEAR THIS
APPLIANCE
• THIS BARBECUE IS ONLY TO BE
USED OUTDOORS.
Direction for
tightening
A
