Rinnai New Zealand
Continuous Flow Water Heater Operation Manual
01-09
17
Setting the
clock
Setting the
sound options
Adjusting
temperature
The clock is a 12 hour AM/PM display. To set the time press the ‘Clock’
button once. In the digital monitor the clock digits will flash, if this is the
first time the clock has been set the starting time will be AM 12:00.
Use the up and down buttons to select the desired time. Holding these
buttons down continuously cycles the digits. When you get close to the time
y
ou wish to set, press the button intermittently to
av
oid going further than
the desired time.
T
o return to normal mode, press the ‘Clock’ button once. If no buttons are
pressed for appr
oximately 60 seconds the controller will return to normal
mode.
The time is always display
ed regardless of whether the controller is turned
On or Off
. The clock ma
y need resetting if power to the
water heater is
disrupted due to a power failure or if the power is switched off o
ver a
prolonged period.
To set the sound options press the ‘Sound Volume’ button and select the
desired audible setting as follows:
V
oice High, Med, Low or off, sets the
voice prompt volume but does not
affect the ‘beep’ sound when pressing the buttons
Sound Off, mutes all
voice prompts and audible tones.
Press the up and down buttons to return to normal mode. If no buttons are
pressed for appr
oximately 10 seconds the controller will return to normal
mode.
Press the ‘Temperature’ up and down buttons until the required temperature
is displayed.
Once the hot w
ater is running, if the set tempe
rature is either too hot
or cold, press the ‘
Temperature’ up and down buttons until the desired
temperature is reached.
•
•
Bathroom Deluxe Controller
Summary of Contents for 09.12 Series
Page 27: ......
