4
Classic Inclusion Steps:
1. Initiate add flow in the Ring Alarm mobile application – Follow the guided add flow
instructions provided in the Ring Alarm Mobile application
2. Select add manually and enter the 5 digit DSK pin found on the package of the Ring
Alarm Retrofit Kit or the 5 digit DSK pin found on the inside of the top cover of the device.
3. Press the Learn Button below the battery terminals, and the device will enter classic inclusion
mode which implements both classic inclusion with a Node Information Frame, and Network
Wide Inclusion. During Classic Inclusion mode, the Green LED will blink three times every
three seconds. When Classic inclusion times-out, the device will blink red and blue.
Ring Alarm Retrofit – Exclusion
Removing Ring Alarm Retrofit from a Z-Wave Network
Exclusion Instructions:
1. Initiate remove “Ring Alarm Retrofit” flow in the Ring Alarm mobile application – Select the
settings icon from device details page and choose “Remove Device” to remove the device,
place the controller into Remove or “Z-Wave Exclusion” mode.
2. Then remove the batteries from the device, and then re-insert them. The device’s RED LED
turn on solid if successful.
Ring Alarm Retrofit – Reset
Factory Default Instructions
1. To restore Ring Alarm Retrofit to factory default settings, locate the pinhole on the middle
of the front of the sensor and insert a paper clip in the hole. Hold the button down for 10 seconds.
2. The device will blink continuously for 10 seconds. Release the button when the RED LED is solid.
Note: Use this procedure only in the event that the network primary controller is missing or otherwise
inoperable.
Led behavior for Inclusion
Blink Pattern
Smart Start Started
Green LED Three Times
Classic Inclusion Started
Green LED Three Times every three seconds.
Classic Inclusion Timed-Out
Green and Red several times.
Inclusion Successful (Authenticated S2)
Green LED on solid
Inclusion Not Successful (Self-Destruct)
Red LED on solid
