background image

This device complies with part 15 of the FCC Rules and 

Industry Canada licence-exempt RSS standard(s). Opera-

tion is subject to the following two conditions: (1) this 

device may not cause interference, and (2) this device must 

accept any interference, including interference that may 

cause undesired operation of the device.

Le présent appareil est conforme aux CNR d'Industrie 

Canada applicables aux appareils radio exempts de 

licence. L'exploitation est autorisée aux deux conditions 

suivantes : (1) l'appareil ne doit pas produire de brouillage, 

et (2) l'utilisateur de l'appareil doit accepter tout brouillage 

radioélectrique subi, même si le brouillage est susceptible 

d'en compromettre le fonctionnement.

This equipment has been tested and found to comply with 

the limits for a Class B digital device, pursuant to part 15 of 

the FCC Rules. These limits are designed to provide reason-

able protection against harmful interference in a residential 

installation. This equipment generates, uses and can 

radiate radio frequency energy and, if not installed and 

used in accordance with the instructions, may cause 

harmful interference to radio communications. However, 

there is no guarantee that interference will not occur in a 

particular installation. If this equipment does cause harmful 

interference to radio or television reception, which can be 

determined by turning the equipment off and on, the user 

is encouraged to try to correct the

interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and 

receiver.

• Connect the equipment into an outlet on a circuit different 

from that to which the receiver is connected.

• Consult the dealer or an experienced radio/TV technician 

for help.

Caution: Any changes or modifications to this device not 

explicitly approved by manufacturer could void your 

authority to operate this equipment.

MPE Reminding

To satisfy FCC / IC RF exposure requirements, a separation 

distance of 20 cm or more should be maintained between 

the antenna of this device and persons during device 

operation.

To ensure compliance, operations at closer than this 

distance is not recommended.

Les antennes installées doivent être situées de facon à ce 

que la population ne puisse y être exposée à une distance 

de moin de 20 cm. Installer les antennes de facon à ce que 

le personnel ne puisse approcher à 20 cm ou moins de la 

position centrale de l’ antenne.

La FCC des éltats-unis stipule que cet appareil doit être en 

tout temps éloigné d’au moins 20 cm des personnes 

pendant son functionnement.

Summary of Contents for 5B11S8








Reviews: