9
FIG. 10
FIG. 11
ASSEMBLY
FIG. 12
INSTALL THE DISC SANDING TABLE
21. An adjustable Handle and Washer (#47,
125) are supplied to hold the Sanding Disc
Table (#120) in position on the sanding base.
22. Line the disc sanding table’s slotted right
end with the curved keyway in the sanding
disc base. Position it in the keyway so that
the handle can be installed, fastening the
parts together. FIG. 10.
NOTE:
It is easier to thread the bolt part
of the handle on first, then attach the handle
to it using the spring loaded Allen head cap
screw provided.
23. Attach the Angle Scale Pointer (#133) to
the sanding disc frame with the M4 Phillips
pan head screw and washer (#134, 128). The
pre-drilled hole is located just below the angle
gauge. FIG. 11.
Adjust the pointer after the table is set
to 90°, see page 14.
The disc table will tilt from 45° to 90°. FIG. 12.
INSTALL THE BELT SANDING TABLE
24. An adjustable Handle and Washer (#47,
48) are supplied to hold the Sanding Belt
Table (#45) in position on the Sanding
Frame (#21).
25. Position the sanding belt table around
the belt, and so that it’s lower bracket with
the curved slot is in postion with the threaded
hole in the frame.
26. Fasten the table in place. Thread the
bolt portion of the locking adjustable handle
through the bracket’s slot and into the thread-
ed hole of the sanding frame. FIG. 13.
The table will tilt from 45° to 90°. FIG. 14.
NOTE:
See pages 13 and 14 for addtional
information on adjusting the sanding tables.
Tables should be adjusted to
a distance of about 1/16” away from the sand-
ing disc or belt to prevent accidents if work
or your fingers get stuck in the gap while the
sander is running.
FIG. 13
FIG. 14
CURVED KEYWAY
ANGLE SCALE &
POINTER
