8
ASSEMBLY
FIG. 6
FIG. 7
FIG. 8
FIG. 9
INSTALL THE INSIDE BELT GUARD
12. The inside metal cover Guard (#108) fits
between the motor and the belt guard (#106).
13. Position the metal guard inside of the belt
guard. The bent tabs will keep it in place, then
secure it with the long M4 Phillips head screw
(#102) and wing nut (#109). FIG. 6.
INSTALL THE SANDING DISC
14. Make sure the metal Sanding Disc (#100)
is clean of foreign material.
NOTE:
This disc only takes PSA (pressure
sensitive adhesive) sanding abrasives.
15. Peel the protective backing from the
supplied Sandpaper Disc (#99), center it on the
metal disc, and press it in place.
16. Install the sanding disc onto the motor
arbor. Line up the disc’s keyway to the motor’s
shaft key and slide the disc in place. Align the
disc up with the disc guard so it is slightly proud
of the cover. This enables the workpiece to
pass by it without rubbing.
17. Tighten the disc onto the motor shaft with
the pre-installed hex screw (#101). You can get
access to it through the hole in the cover guard.
FIG. 7.
INSTALL THE DUST PORT
18. Attach the Dust Port (#127) to the sanding
disc base using the M6 Phillips head screw and
lock washer (#128, 129). FIG. 8.
19. The Dust Port has a 1-3/4” internal dia-
meter, and 2” outer diameter for use with a 2”
flex hose to your dust collector.
INSTALL THE LOWER DISC GUARD
20. Attach the metal, lower Disc Guard (#130)
to the sanding disc base with the three M4
Phillips head screws and washers (#131, 63).
FIG. 9.
