12
ASSEMBLY
REMOVING THE CHUCK
1. Open the chuck jaws as wide as possible to
prevent damage.
2. Lower the spindle until the slot in the spindle is
exposed. (Fig. 14)
3. Position the table approximately 1/2” below
the extended chuck.
4. Turn the chuck until a through hole is exposed
in the spindle.
5. Insert the Key-drift provided into the slot
(Fig. 15)
6. Gently tap the key-drift with a mallet to release
the chuck.
NOTE:
To avoid damage to the chuck, make
sure to place a hand below the chuck to catch it
as it is released from the spindle.
Figure 14
Figure 15
THE MACHINE MUST NOT BE
PLUGGED IN AND THE POWER SWITCH MUST BE IN
THE OFF POSITION UNTIL ASSEMBLY IS COMPLETE.
B
A
Figure 16
RAISING AND LOWERING THE TABLE
1. Loosen the column lock handle (A-Fig. 16) on
the table support bracket (B-Fig. 16).
2. Turn the crank handle (C-Fig. 16) to raise or
lower the table to the desired height.
3. Tighten the column lock handle (A-Fig. 16).
NOTE:
The table assembly can rotate 360
o
around the column by loosening the table lock
handle and turning the table to the desired
position. The column collar’s hex nut may have to
be loosened to allow the table assembly with the
rack to be rotated. Retighten the collar nut when
the table is in final position.
C
Parts Diagrams and Parts Lists
can be found on pages 18 to 21.
ADJUSTMENTS
