16
MAINTENANCE
WARNING:
This machine must be grounded. Replacement of the power supply cable or any
electrical repairs should only be done by a qualified electrician.
See page 5 for additional electrical information.
WIRING DIAGRAM
Turn the power switch “OFF” and disconnect the plug from the outlet prior
to adjusting or maintaining the machine. DO NOT attempt to repair or maintain the electrical
components of the motor. Contact a qualified service technician for this type of maintenance.
1. Before each use:
- Check the power cord and plug for any wear
or damage.
- Check for any loose screws, hardware or
parts.
- Check the area to make sure it is clear of any
misplaced tools, lumber, cleaning supplies,
etc. that could hamper the safe operation of
the machine.
2. To avoid a build-up of wood dust, regularly
clean all parts of the machine using a soft cloth,
brush or compressed air. A general cleaning
should be done after every use to avoid future
problems and ensure the machine is in ready
condition for its next use.
WARNING:
If blowing sawdust, wear proper eye
protection to prevent debris from blowing into
eyes.
3. Keep the machined surfaces of the drill press
table and base free of resin and rust. Clean them
regularly with a non-flammable solvent, then coat
with a light film of dry lubricant spray or wax.
4. Lubricate the table bracket and locking lever
bolts to keep them operating smoothly.
5. Clean the column on a regular basis to
prevent
the build-up of dust, drilling residue and
rust. Treat the posts with a dry lubricant spray
or a light coating of wax. Do not use ordinary oil
which will collect dust and hamper the movement
of parts along the column.
6. Periodically, lower the quill assembly and
apply a light coating of machine oil to the quill
and spindle surfaces. Raise and lower the quill a
few times to distribute the oil on all of the internal
surfaces.
7. Apply #2 tube grease to the worm gears in
the table elevation mechanism and the rack bar
to keep them operating smoothly.
8. The ball bearings in the spindle and pulley
assemblies are lifetime lubricated, sealed, and
do not need any further care.
9. Keep the drive belt and pulley surfaces free of
oil and grease. Periodically, check the drive belt
for wear and replace if necessary.
Troubleshooting Guide
is listed on page 22.
