13
4. Choose the desired speed by referring to the
speed selection chart that is attached to the lid
interior.
5. Position the belts on the pulleys in relation to
the speed chosen on the speed selection chart
starting with the motor pulley first. (Figure 16).
6. When both belts are in the desired positions
on the pulleys, swing back the tension lever until
there is approximately 1/2” deflection in the belt.
7. Tighten the locking knob on the both sides of
drill press head to secure the belt position and
tension in place for operation.
ADJUSTMENTS
Figure 16
8. Close the top belt guard cover and the drill
press is ready to be plugged in to use.
SETTING THE SPINDLE LOCK
1. Loosen the depth stop collar locking screw (#6D)
that extends out from the hub. (Figure 17, A).
2. Lower the spindle to the desired depth for drilling.
NOTE:
Photo shown without drill bit installed in the
drill chuck. (Figure 18)
3. Turn the depth stop collar clockwise until the
collar stops (Figure 17, B).
4. Tighten the depth stop collar lock.
Figure 17
SETTING THE DRILL DEPTH
1. With the spindle in the up position, loosen the
depth stop collar lock as shown. (Figure 17, A)
2. Turn the depth stop collar clockwise until the
pointer reads the desired drill depth on the scale
(Figure 17, B).
3. Tighten the depth stop collar lock. The drill press
is now set for repetitive drilling to the same depth.
Figure 18
NOTE:
Figure 18 shows the spindle in the
locked position.
THE MACHINE MUST
NOT BE PLUGGED IN AND THE POWER
SWITCH MUST BE IN THE OFF POSITION
UNTIL ALL ADJUSTMENTS ARE COMPLETE.
A
B
SPINDLE
SHOWN
IN THE
LOCKED
POSITION
(WITHOUT
DRILL BIT
INSTALLED)
