ASSEMBLY
9
BASE AND COLUMN ASSEMBLY
1. Place the Base (Part #1A, Figure 1, A) on a level floor
where the machine will be used. FIG. 1.
2. Attach the Column (#3A, B) to the base using four
M10x40 hex Bolts (#2A). Tighten all four bolts.
NOTE:
The column is shipped with the toothed Rack
(#4A), Collar Rack (#10A) and Table Arm Assembly
pre-assembled on the column. The column should be
positioned on the base with the table arm facing forward
with the rack to the right side of the column.
3. Check the Hex Screw (#22A) on the rear of the
support column (B), and the Hex Screw (#11A) on the
Collar Rack (#10A) to make sure that they are secure.
INSTALLING THE TABLE
1. Install the large Locking Lever (#12A) onto the
rear joint of the table support bracket and tighten the
locking lever. FIG. 2.
2. Install the table raising/lowering crank Handle (#6A)
to the side shaft of the Table Support (#7A) with a hex
wrench. FIG. 3.
3. If not pre-installed at the factory, install the small
Locking Lever (#18A, Fig. 4, A) onto the front joint of
the Table Support Bracket (#17A, B). FIG. 4.
4. Insert the table post (C) into the table support
bracket (B) as shown in Figure 4. Tighten the locking
lever (A) to secure the table in position.
FIG. 3
FIG. 1
FIG. 4
FIG. 2
THE MACHINE MUST NOT BE
PLUGGED IN AND THE POWER SWITCH MUST BE IN
THE OFF POSITION UNTIL ASSEMBLY IS COMPLETE.
B
A
B
A
C
NOTE:
Parts referenced throughout the manual
refer to the different sheets and key numbers of the
Parts Diagrams and Parts Lists on pages 28 to 39.
Example: (#1A) refers to Part #1 on Sheet A.
LINK TO THE #30-217
ASSEMBLY VIDEO INSTRUCTIONS
ON THE RIKON WEBSITE
WWW.RIKONTOOLS.COM
