FIG. 1
ASSEMBLY
THE MACHINE MUST NOT BE PLUGGED IN AND THE POWER SWITCH
MUST BE IN THE 'OFF' POSITION UNTIL ASSEMBLY IS COMPLETE.
FIG. 2
Unpacking and Clean-up
1. Carefully finish removing all contents from shipping carton. Compare contents of the shipping
carton with the list shown on page 8. Place parts on a protected surface.
2. Report any shipping damage to your local distributor. If parts are missing contact RIKON
customer service at 877-884-5167 or [email protected].
3. Clean all rust protected surfaces.
Do not use
; gasoline, paint thinner, mineral spirits, etc.
These may damage painted surfaces.
4. Set packing material and shipping carton to the side.
Do not discard
until the machine has
been completely set up and is running properly.
1. Install the column onto the base using the
three column mounting bolts. FIG. 1.
2. Slide the table onto the column and install the
table lock handle through the un-threaded
hole on the left of the table support casting.
The handle should engage the thread on the
right side of the table support casting.
FIG. 2.
Tools Required for Assembly
Phillips Screwdriver
Adjustable or 13mm Wrench
9
Parts Diagrams and Parts Lists
can be found on pages 15 to 18.
Summary of Contents for 30-100
Page 16: ...16 PARTS DIAGRAM B...
