THE MACHINE MUST NOT BE
PLUGGED IN AND THE POWER SWITCH MUST BE IN
THE 'OFF' POSITION UNTIL ASSEMBLY IS COMPLETE.
ASSEMBLY
FIG. 3
10
3. Slide the drill press head onto the column.
FIG. 3.
4. Center the drill press head over the table and
base. Tighten the drill press head into position
by locking the two hex screws on the side of
the casting.
FIG. 4, A.
6. Slide the 1/2” chuck (FIG. 5, A) over the
pre-installed spindle (B). Open the
chuck jaws fully and tap into place using a
rubber mallet or a hammer and block of wood.
This will properly seat the chuck onto the
spindle.
FIG. 5
FIG. 4
A
A
B
NOTE: NEVER HIT THE CHUCK ASSEMBLY
WITH A METAL HAMMER. This could damage
the chuck or spindle.
NOTE:
It is important that the tapered chuck
mounting hole and tapered spindle are free of
any grease, oil or rust protection before they are
installed together in step 6.
These tapered surfaces must be absolutely clean
for a precision fit, so slipping of the chuck does
not occur unless there is extreme rotational
pressure during use. This is a safety feature of
this type of friction fit joint.
Use ordinary household grease remover to clean
these mating surfaces.
5. Install the small, belt cover knob on to the right
side of the top lid (FIG. 3, A). Open the belt
cover and insert the Phillips head screw
through the hole in the lid from the inside.
Thread the handle on the outside of the belt
cover and tighten it in place with a screwdriver.
A
7. Install the 3 feed handles onto the threaded
holes in the handle hub. FIG. 6.
FIG. 6
Summary of Contents for 30-100
Page 16: ...16 PARTS DIAGRAM B...
