ASSEMBLY
SETTING THE TABLE SQUARE TO SAW BLADE
The table may be set at 90° to the saw blade’s sides
by adjusting the table stop Bolt (#59, FIG. 6, A). This
Bolt extends up from the frame and touches the table’s
bottom skirt under its left side.
First loosen the locking Nut (#57, B), then set a square
between the blade and the work table. Adjust the table
stop Bolt, up or down, until the table and blade are set
at 90°. Retighten the locking nut making sure that the
setting is maintained.
While pre-set before shipping, if needed, the table may
also be re-set at 90° to the back of the saw blade.This
is done by adding thin shims between the table bottom
and trunnions (FIG. 7, C).
Slightly loosen the four table Bolts (#87) (refer to parts
diagram on page 26). Slide paper, plastic or metal shims
between the trunnion and table castings near where the
bolts are positioned. Check table and blade angle with a
square and shim as needed until the desired 90° setting
is achieved. Re-tighten the bolts to secure the table in
postion.
TILTING THE TABLE
Loosen the front and two rear lock handles on the
table trunnion (#24, 62, FIG. 8). Adjust the table to the
desired tilt angle. Use the angle indicator scale on the
trunnion bracket to find the table angle. Retighten the
lock handles to secure the table in positon.
FIG. 5
11
FIG. 6
A
B
FIG. 7
FIG. 8
TOOL STORAGE
Storage for the “L” Hex Wrenches is provided for quick
access when adjustments are needed. Place the (4)
wrenches (3mm, 4mm, 5mm and 6mm) in the tool
holder (#2) on the rear column supp
ort. FIG. 5.
A Hex Socket Screw and Nut (#6,5) are provided to
hang the push stick. If not pre-installed before shipping,
mount this hardware on the left side of the column, in
the prepared threaded hole. FIG. 5.
ADJUSTMENTS
MOTOR
PULLING
ROD
page 15
TABLE
STOP
C
UNDERSIDE
of TABLE
C
C