2 Maintenance Mode
- 11 -
SC-8000
<Bump Test Setting "BUMP-SET">
Check and set the setting items related to the bump test.
BUMP-SET
Press the ENTER switch.
Press the
▲
or
▼
switch to display a target setting
item to be checked or set.
The test time is displayed.
Press the ENTER switch. The numeric display blinks,
prompting for input. Press the
▲
or
▼
switch to enter
introduction time. Press the ENTER switch to confirm it.
The figure on the right shows an example of 30
seconds.
(Test time: 30, 45, 60, or 90 seconds)
The test pass tolerance range is displayed.
Press the ENTER switch. The numeric display blinks,
prompting for input. Press the
▲
or
▼
switch to enter a
range. Press the ENTER switch to confirm it.
The figure on the right shows an example of range
within ±30%.
(Pass range: Within ±10%, ±20%, ±30%, ±40%, or
±50%)
The adjustment time after test fail is displayed.
Press the ENTER switch. The numeric display blinks,
prompting for input. Press the
▲
or
▼
switch to enter
adjustment time. Press the ENTER switch to confirm it.
The figure on the right shows an example of 60
seconds.
Whether or not to enable automatic adjustment after
test fail is displayed.
Press the ENTER switch. The ON (OFF) display blinks,
prompting for input. Press the
▲
or
▼
switch to select
ON or OFF. Next, press the ENTER switch to confirm it.
ON: Automatic adjustment enabled OFF: Automatic
adjustment disabled.
The figure on the right shows an example of ON
setting.
When the setting is completed, press the
▲
or
▼
switch until ESCAPE is displayed. Press the ENTER
switch to return to the maintenance mode menu.
Return to BUMP-SET.
