RIKA INTERNO, Gsm Operating Manual

Page: 28 / 40

5. EXPLANATIONS
To activate the GSM function, the GSM setting must be set to ON under the SETUP / Settings menu. You must also set the four-digit reception
code.
You can select this code free. (On the following pages the numbers 1234 are used by way of example to make the instructions comprehensible.)
The reception code is used to prevent unauthorised access to your GSM Modem.
According to a successfully command code a confirmation message will be sent. This is not possible when you suppress your telephone number!
Important
To get answer messages enough credits on the SIM-card are necessary.
The GSM function is only possible in the extended comfort modes (HEAT/ROOM/AUTO), not in EASY Mode.
Note:
When the GSM has been properly connected to the stove‘s interface and the plug has been inserted into the power socket, the LED display on the
modem will flash orange at brief intervals. If there is adequate reception, the orange display will flash at long intervals.
Assembly steps
For the right positioning of the GSM modem /optional wireless room sensor you find the precut perforations on the support plate of the
motherboard.
1. Then the supplied GSM assembly plate is attached with two M4 screws, washers and nuts (wireless room sensor four M4).
2. Attach GSM modem to the assembly plate using M3 x 20 mm slotted cheese head screws.
3. The mini antenna is screwed into the GSM modem, depending on the type of stove possibly from the outside of the rear panel.
Mounting examples:
4. Now the mains plug and the enclosed cable adapter can be attached to the GSM modem. Attach the cable adapter with the two knurled
screws to the GSM modem.
5. Plug the free connector of the cable adapter into the D-subconnector and tighten using a small screwdriver.
When all steps have been carried out, the rear panel can be reattached to the pellet stove.
28