Rigol MSO5000-E Series, Quick Manual

Page: 15 / 45

RIGOL
MSO5000-E Quick Guide 13
English
Figure 9 Square Waveform Signal
6. Use the same method to test the other channels. If the square waveforms
actually shown do not match that in the figure above, please perform
relevant procedures specified in "Probe Compensation".
WARNING
To avoid electric shock when using the probe, please make sure
that the insulated wire of the probe is in good condition. Do not
touch the metallic part of the probe when the probe is connected
to high voltage source.
Probe Compensation
When the probes are used for the first time, you should compensate the probes
to make them match the input channels of the oscilloscope. Non-compensated
or poorly compensated probes may cause measurement inaccuracy or errors.
The probe compensation procedures are as follows:
Tip
The probe compensation signal can only be used for probe compensation
adjustment and cannot be used for calibration.