-
Press for three seconds to directly shut down the instrument.
TIP
You can also click or tap
>
Utility
>
Setup
and select "Switch On" in "Power Status" item.
In this way, the instrument powers on once connected to power.
5.4
Setting the System Language
This oscilloscope supports multiple languages. You can click or tap
>
Utility
>
Setup
>
Language
to select the system language.
5.5
Connecting Probes
RIGOL provides passive and active probes for HDO4000 series. For specific probe
models, please refer to
HDO4000 series Data Sheet. For detailed technical information
of the probes, please refer to the corresponding Probe User Guide.
Connect the Passive Probe
1.
Connect the BNC terminal of the probe to an analog channel input terminal of the
oscilloscope on the front panel as shown in the figure below.
2.
Connect the ground alligator clip or spring of the probe to the circuit ground
terminal, and then connect the probe tip to the circuit point to be tested.
Figure 5.3 Connecting the Passive Probe
To Prepare for Use
14
Copyright ©RIGOL TECHNOLOGIES CO., LTD. All rights reserved.
www.calcert.com
1.800.544.2843
0
5
10
15
20
25
30