RIGOL
DS1000B Service Guide
1-1
Chapter 1
Specifications
All the specifications apply to the DS1000B series oscilloscopes unless otherwise
noted. To meet these specifications, the oscilloscope should meet the following two
conditions.
The instrument must have been operating continuously for at least 30 minutes
under the specified operating temperature.
You have to perform the “Self Cal” operation, accessible through the Utility menu,
if the operating temperature variation is equal to or greater than 5°C.
Note:
The vertical scale values are measured by a probe with 1X attenuation ratio
unless otherwise noted.
All the specifications are guaranteed unless those marked with “typical”.
