Rigol DG952, Programming Manual

Page: 144 / 205

RIGOL Chapter 2 Command System
2-132 DG900 Programming Guide
[:SOURce[<n>]]:SWEep:TRIGger:SOURce
Syntax
[:SOURce[<n>]]:SWEep:TRIGger:SOURce {INTernal|EXTernal|MANual}
[:SOURce[<n>]]:SWEep:TRIGger:SOURce?
Description
Sets the sweep trigger source of the specified channel to Internal (INTernal), External (EXTernal), or
Manual (MANual).
Queries the trigger source of the sweep of the specified channel.
Parameter
Name Type Range Default
[<n>] Discrete 1|2 1
{INTernal|EXTernal|MANual} Discrete INTernal|EXTernal|MANual INTernal
Remarks

The generator outputs continuous sweep waveforms when the internal trigger is selected. The trigger
period is determined by the specified sweep time ( [:SOURce[<n>]]:SWEep:TIME ), return time
( [:SOURce[<n>]]:SWEep:RTIMe ), start hold ( [:SOURce[<n>]]:SWEep:HTIMe:STARt ), and stop hold
time ( [:SOURce[<n>]]:SWEep:HTIMe[:STOP] ).

In the External trigger, the signal generator receives the trigger signal input from the rear-panel
[Sync/Ext Mod/Trig/FSK] connector of the specified channel. Once it receives a TTL pulse
( [:SOURce[<n>]]:SWEep:TRIGger:SLOPe ) with a specified polarity, a sweep is initiated.

In the Manual trigger, the instrument initiates a sweep on the corresponding channel immediately each
time the trigger command ( [:SOURce[<n>]]:SWEep:TRIGger[:IMMediate] ) is sent (the trigger
command is only valid when the output of the specified channel is enabled).

When [:SOURce[<n>]] or [<n>] is omitted, the system sets the related parameters of CH1 by default.
Return Format
The query returns INT, EXT, or MAN.
Example
:SOUR1:SWE:TRIG:SOUR INT /*Sets the trigger source of the sweep of CH1 to Internal.*/
:SOUR1:SWE:TRIG:SOUR? /*Queries the trigger source of the sweep of CH1 and the query returns
INT.*/