RIGOL
Quick Guide for DG5000
6
Enable to change Frequency/Period, Amplitude/High Level, Offset/Low Level,
Symmetry and Start Phase of the Ramp waveform.
8.
Pulse
Generate a Pulse waveform with frequency from 1 μHz to 50 MHz and variable
pulse width and edge time.
When the function is enabled, the backlight of the button turns on.
Enable to change Frequency/Period, Amplitude/High Level, Offset/Low Level,
Pulse Width/Duty Cycle, Leading Edge Time, Trailing Edge Time and Delay
of the Pulse waveform.
9.
Noise
Generate a Gauss Noise with bandwidth up to 250 MHz.
When the function is enabled, the backlight of the button turns on.
Enable to change Amplitude/High Level and Offset/Low Level of the Noise
waveform.
10.
Arb
Generate an arbitrary waveform with frequency from 1 μHz to 50 MHz.
Provide two output modes: “Normal” and “Play”.
Generate 10 built-in waveforms: DC, Sinc, Exponential Rise, Exponential Fall,
ECG, Gauss, Haversine, Lorentz, Pulse and Dual-Tone; generate arbitrary
waveforms from USB flash device; generate arbitrary waveforms edited
online (512 kpts) or through PC software and then downloaded to the
instrument by the users; support wavetable points up to 128 Mpts.
When the function is enabled, the backlight of the button turns on.
Enable to change Frequency/Period, Amplitude/High Level, Offset/Low Level
and Start Phase of the arbitrary waveform.
11.
User-defined Key
For some frequently used menus with “deep” location, users can define them as
shortcuts (under the function key
Utility
). And then, in any operation interface,
press the
User-defined Key
to quickly open and set your desired menu or
function.
12.
Page Up/Down
Open the previous or next page of the current function menu.
13.
Menu Softkey
Press any softkey to activate the corresponding menu.
