A
B
C
D
E
Step 1
Locate vehicle battery on the driver side under the
hood and disconnect the negative battery terminal.
Step 2
Chevrolet Malibu
Open the vehicle trunk. Remove the fasteners securing the
felt trunk liner on the driver side. Pull back on the trunk liner to
locate the plastic wing nuts securing the taillight assembly (A).
Remove the three plastic wing nuts securing the taillight assembly.
Locate the vehicle taillight wiring harness connectors. The
connectors will be similar to those on the custom wiring
harness. Separate the connectors from the taillight housing
taking care not to damage the locking tabs. Repeat on the
passenger side (B).
Chevrolet Traverse / Buick Enclave
Open vehicle tailgate. Remove the two bolts securing the taillight
assembly on the driver side. Remove the taillight assembly
to locate the vehicle taillight wiring harness connectors.
The connectors will be similar to those on the custom wiring
harness. Separate the connectors from the taillight housing
taking care not to damage the locking tabs. Repeat on the
passenger side (C).
Step 3
Insert the custom wiring harness end with yellow wire between
the separated connectors. Make sure the connectors are fully
inserted with locking tabs in place (D).
Step 4
Route the custom wiring harness end with the green wire
down through the opening underneath the taillight assembly
(E). Route the wire along the backside of the bumper and up
through the opening on the passenger side. Repeat step 2 on
the passenger side using the harness end with the green wire.
Step 5
Locate a suitable grounding point near the connector such as
an existing screw with nut in the vehicle frame or drill a 3/32"
pilot hole for the provided screw. The area should be free of
rust, dirt and paint. Secure the white ground wire using the ring
terminal and provided screw.
WARNING:
Check for miscellaneous items that may be
hidden behind or under any surface before drilling to avoid
damage and / or personal injury.
Step 8
When in use, route the 4-flat to the center of the vehicle. When
not in use, roll up and store in a convenient, out of the way
location. Secure any loose wires with the provided cable ties.
Step 9
Reinstall all items removed during install and
reconnect
negative battery terminal. Install the provided 4-flat dust
cover to help prevent corrosion.
INSTALLATION / SAFETY INSTRUCTIONS
56027-INS-RB • PAGE 2
