8
OR CASTER
OR COUNTER-CLOCKWISE TO LOWER IT. FOLD
WORKSURFACE TO THE DESIRED HEIGHT AND ANGLE.
THE CRANK HANDLE BACK UNDER THE FIXED WORKSURFACE. ADJUST THE MOVABLE
6
5
9
WORKSURFACE
7
SUPPORT
STEP 8:
WITH THE HELP OF AN ASSISTANT, SET THE WORKSTATION UPRIGHT IN ITS
FINAL LOCATION. LEVEL THE WORKSTATION IF REQUIRED BY TURNING THE LEVELING
GLIDES CLOCKWISE (FROM THE TOP) ON THE LOW CORNERS OF THE UNIT. IF YOUR
WORKSTATION HAS CASTERS, TURN THE BOLTS AT THE TOP OF THE CASTERS CLOCK-
WISE TO LEVEL THE UNIT.
TO OPERATE:
DROP THE MOVABLE WORKSURFACE
11
USING THE INSTRUCTIONS
THAT CAME WITH THE SWING ARM
10
. UNFOLD THE CRANK. TURN IT CLOCKWISE
TO RAISE THE FIXED WORKSURFACE
1
LEVELING GLIDE
FOOT
DETAIL A
PRE-INSTALLED
T-SLOT PLATE
STEPS 4-6
6703 ZINSER ST., SCHOFIELD, WI 54476
PHONE: 800.298.4351 FAX: 866.882.9475
www.raproducts.com
VERSION DATED: 3/6/12
K&A MANUFACTURING
PAGE 2 OF 2
STEP 4:
WITH THE HELP OF AN ASSISTANT, PLACE (4) STAR WASHERS
6
ON (4) SOCKET SCREWS
7
. INSERT
THESE THROUGH THE HOLES AT THE ENDS OF THE CROSS SUPPORT
5
AND THREAD THEM INTO THE T-SLOT
PLATE THAT IS PRE-INSTALLED IN THE SLOT IN THE COLUMN ASSEMBLIES
2
AND
3
. SEE DETAIL A BELOW.
DO NOT FULLY TIGHTEN.
STEP 5:
LEVEL THE CROSS SUPPORT
5
AT 4" FROM THE BOTTOM OF THE WORKSURFACE SUPPORT AND FULLY
TIGHTEN THE SOCKET SCREWS
7
. SEE THE DETAIL BELOW.
SPECIAL EXCEPTION: ON WORKSTATIONS ON WHICH
THE LifeBalance STATION IS BEING INSTALLED, THE CROSS SUPPORT SHOULD BE INSTALLED RESTING ON THE FEET
OF THE COLUMN ASSEMBLIES TO ALLOW FOR CLEARANCE OF THE EQUIPMENT.
STEP 6:
ALIGN THE HOLES IN THE WORKSURFACE SUPPORTS WITH THE PILOT HOLES IN THE WORKSURFACE
1
.
ATTACH THE WORKSURFACE SUPPORTS TO THE WORKSURFACE USING (16) WOOD SCREWS
9
. DO NOT OVER-
TIGHTEN THE SCREWS. USE A LOW TORQUE SETTING ON THE DRILL.
STEP 7:
PLACE THE MOVABLE WORKSURFACE
11
ON THE PROTECTED SURFACE IN FRONT OF THE FIXED WORK-
SURFACE
1
KEEPING A 1/2" SPACE BETWEEN THE WORKSURFACES. PLACE THE SWING ARM
10
ON THE WORK-
SURFACES. ALIGN THE HOLES IN THE SWING ARM AND RELEASE PADDLE WITH THE PILOT HOLES IN THE WORK-
SURFACES. ATTACH THE SWING ARM USING THE INSTRUCTIONS THAT CAME WITH THE ARM. THE SCREWS ARE
INCLUDED WTH THE ARM.
(SEE EXCEPTION IN STEP 5)
LOCATING THE CROSS SUPPORT
5
BOTTOM OF
WORKSURFACE
SUPPORT
4.00
11
10
STEP 7
