will require the power to be removed, Press and hold the button for a minimum of 10 seconds before powering again.
7.
Close battery compartment door, snapping it into place.
8.
Push test button to test alarm. See “
TESTING THE SMOKE ALARM
” for details.
CAUTION
: Due to the loudness of the alarm, always stand at an arm’s length away from the unit when testing.
OPERATING YOUR CO ALARM
VARIOUS STATUS OF THIS ALARM (TABLE2)
Current Status
Alarm LED
Power LED
Horn
Description
Normal Operation
Off
1 Flash every
60seconds
Silent
The device is on the normal
self-testing status
Local Alarm
Flashing
accompany with
alarming sound
Off 4
beeps-pause-
4
beeps
carbon monoxide is detected by
the device and trigger the device
to alarm
Remote Alarm
Off Off
Alarming
sound
The device is triggered to alarm
by receiving the wireless alarm
signal from other device
Locate Alarm
Flashing
accompany with
alarming sound
Off 4
beeps-pause-
4
beeps
Only Local alarm
can be
in this
state, but it cannot transmit the
alarm signal out
Hush State
1 flash every 10
seconds
Off Silent
The device is silent
Low Battery
Off
--
1 beep every 60
seconds
Low battery warning
Off --
The horn sounds
3 quick “chirps”
every minute.
Malfunction
Off --
The horn sounds
2 quick “chirps”
following with 1
long “chirp”.
The device is in malfunction,
need to be replaced
The device has TEST, HUSH, LOCATE functions which can be implemented by pressing the button with different holding time
under various status.
Button Definition as below:
(TABLE3
)
