37
TECHNICAL ASSISTANCE SERVICE
Once you have completed all the preparatory steps,
proceed as follows to start up the boiler for the first time:
- If the system is equipped with a temperature controller or
timer thermostat, make sure that it is switched on
- Adjust the timer thermostat/s or temperature controller to
the desired temperature (~20°C)
- Turn the system’s main power switch ON
- Make the settings as instructed in the instruction
manual for your control panel.
- Turn the control panel power switch ON and make sure
that the green power indicator lights
The burner should now ignite and remain in operation until the
set temperature is reached.
If any ignition faults or malfunctions occur, the burner
performs a “LOCKOUT SHUTDOWN”. This is shown by
the red button light on the burner and by the warning light
on the control panel.
b
If a “LOCKOUT SHUTDOWN” occurs, wait about 30
seconds before resetting the burner.
To reset the burner, press the red button light on the bur-
ner and wait until the flame ignites.
Repeat this operation 2-3 times at the most. If the pro-
blem persists, perform the following checks:
- All checks listed in the burner's own instruction manual;
- All steps listed in the ‘Preparing for Initial Start-up’ section;
- All the electrical connections shown on the control panel
wiring diagrams.
ON
OFF
Initial start-up
INITIAL START-UP
