20019904
20
GB
Installation
4.9
Electrode position
4.10 Burner refitting
Refit the burner to the slide bars 3)(Fig. 17) at approximately
4” from the sleeve 4) - burner positioned as shown in (Fig. 10,
page 17) - insert the ignition electrode cables and then slide
the burner up to the sleeve so that it is positioned as shown in
(Fig. 17).
refit screws 2)(Fig. 17) on slide bars 3);
secure the burner to the sleeve by tightening screws 1);
connect the oil pipes again by screwing on the two connectors
6)(Fig. 17).
WARNING
Make sure that the electrodes are positioned as
shown in Fig. 16.
5/ 32" to 3/ 16"
3/ 32"
Fig. 16
D10108
WARNING
When fitting the burner on the two slide bars, it is
advisable to gently draw out the high tension cables
until they are slightly stretched.
1
2
3
4
5
6
14
Fig. 17
D10086
