Riello UPS NetMan 204, Installation And User Manual

Page: 18 / 52

- 18 -
IP config
/------------------------/
/ IP config /
/------------------------/
Hostname.......:ups-server
IP address/DHCP:DHCP
Netmask........:
Gateway........:
Primary DNS....:
Secondary DNS..:
With this menu the main network parameters can be set as described in the following table.
Field Parameters to be inserted
Hostname Enter the NetMan 204 host name
IP address/DHCP
Enter the IP address for a static IP; enter “DHCP” for a dynamic IP
Netmask Enter the netmask to be used together with the static IP address
Gateway Enter the name or the address of the network gateway
Primary DNS Enter the name or the address of the preferred DNS to be used
Secondary DNS Enter the name or the address of the alternative DNS to be used
If a static IP address is assigned to the device, all the fields must be configured with the
network parameters. If a dynamic IP address is assigned, just enter ‘dhcp’ in the “IP
Address/DHCP” field and provide a hostname; all the other options should be ignored
because these are automatically configured with DHCP
After pressing “ESC” and “Y” to confirm exit from the menu, a screen similar to the image below is
displayed.
Press the “ENTER” key to return to the main menu and the configuration will be
immediately applied.
eth0 Link encap:Ethernet HWaddr 00:02:63:04:07:b1
inet addr:10.1.11.19 Bcast:10.1.255.255 Mask:255.255.0.0
inet6 addr: fe80::202:63ff:fe04:7b1/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:145877 errors:0 dropped:0 overruns:0 frame:1
TX packets:4899 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:12740380 (12.1 MiB) TX bytes:2115614 (2.0 MiB)