Adjust the dispenser to the crockery used
24
Rieber GmbH & Co. KG
Adjusting the platform to the weight of the crockery
WARNING!
Risk of injury if platform is adjusted incorrectly. When plates are removed from a
stuck platform, crockery parts might shoot out.
►
Distribute springs evenly. Only remove springs at the bottom.
►
Carry out the setup work correctly.
See illustrations at beginning of chapter
Open the casing and/or the separating facility. To that end loosen the hexagon socket screw (1).
▌
The springs are easily accessible.
Place 2 or 3 baskets with crockery parts on the platform.
▌
Spring adjustment is perfect, if the top basket is flush with the edge (or a little
below).
If platform projects, remove the springs again.
If platform does not project enough, install springs.
Close the casing and/or the separating facility again. To that end tighten the hexagon socket screw
(1) firmly.
WARNING!
Risk of injury if dispensing level is below lower edge of casing. Fingers and hands
may get caught.
►
Ensure that the dispensing level is always above the lower edge of the casing.
7.4 Ultra dispenser REU …
Procedure
See chapter ‘Pipe dispenser R …’, page 19
7.4.1 Built-in dispensers E…
Procedure
See chapter ‘Pipe dispenser R …’, page 19
When reinstaling the adjustable pipe, insert the 3 locking clips (1) in the corresponding cutouts (2)
at the upper termination ring of the jacket.
