1. Grasp the drum latches on both the right
and left side of the power head. Slowly
pull the drum latches out and up from
the drum. Lift the power head off the
drum. Place the lid assembly of the vac
upside down.
2. Carefully slide the filter over the filter
cage, sliding filter down until the filter
stops against the lid.
NOTE:
The filter will take the shape of the
oval filter cage when in place.
3. Place the hole in the filter plate over the
threaded screw of the filter cage.
4. Gently push on the filter plate to seat the
rubber ring of the filter inside the circular
channel of the filter plate.
5. Place filter nut onto threaded screw and
tighten it down. Finger tighten only.
NOTE:
Lever of filter nut should be away
from plate as shown.
IMPORTANT:
Do not overtighten as this
may deform or crack the filter plate, filter
cage or filter.
6. To assemble the power head to the
drum, position power head over drum,
with drum latches lined up with recess in
drum. (The power head will only fit on
the drum one way).
7. Position bottom of the latch in drum
recess. Push top of latch towards power
head to lock.
8. Your vac is now ready to use. Read the
instructions on the following pages to
operate your vac safely.
Filter Nut
Filter Plate
Filter
Threaded
Screw
Filter
Cage
Lid
Assembly
6
Filter Assembly/Replacement
Pull Latch
Out From
The Top
And Up
From The
Bottom
Latch (one
on each
side)
Power
Head
S
SP6649_1.qxd 2/14/07 10:53 AM Page 6
