SAE Q-SERIES
Step 1
The illustration blow demonstrates how the nuts will be held in place by the Mount Bushings. This
pertains to both the left and right sides of the housing.
(See Figure Below)
Step 2
You will need to choose if you would like to mount your light in a stationary position or with one larger
bolt, giving you the ability to swivel the light.
(Torque to 212 in/lbs)
(See Figure Below)
Mount Bushing
M6 Square Nut
M8x1.25 Hex Nut
3/8” Hex Nut
Mounting Surface
Stationary Mount
3/8” Flat Washer
Mounting Bracket
3/8” Split Washer
Rubber
Shock
Isolation
Mount
3/8” -16
Carriage
Bolt
Swivel Mount
Mounting Surface
3/8” Flat Washer
Mounting Bracket
3/8” Split Washer
3/8” Hex Nut
Rubber
Shock
Isolation
Mount
3/8” -16
Carriage
Bolt
Step 3
Secure light to mounting bracket by following the diagram below. Be sure to install the washers and
Split washers in the correct order to ensure proper installation. This pertains to both the left and right
sides of the bracket.
(See Figure Below)
M6 x 1.0 Hex Bolt / Split Washer / Flat Washer
M8 x 1.25 Hex Bolt / Split Washer / Flat Washer
Mount Bushing
