14
INSTALLING BITS
See Figure 9.
■
Lock the switch trigger by placing the direction of rotation
selector in center position.
See Figure 4.
■
Open or close chuck jaws to a point where the opening
is slightly larger than the bit size you intend to use. Also,
raise the front of the drill slightly to keep the bit from
falling out of the chuck jaws.
■
Insert drill bit straight into chuck the full length of the
jaws as shown in figure 10.
■
Tighten the chuck jaws on the drill bit.
Note:
Rotate the chuck body in the direction of the ar-
row marked
LOCK
to tighten chuck jaws.
■
Do not
use a wrench to tighten or loosen the chuck jaws.
WARNING:
Make sure to insert drill bit straight into chuck jaws.
Do not insert drill bit into chuck jaws at an angle
then tighten, as shown in Figure 9. This could cause
drill bit to be thrown from drill, resulting in possible
serious personal injury or damage to the chuck.
REMOVING BITS
See Figure 9.
■
Lock the switch trigger by placing the direction of rota-
tion selector in center position.
See Figure 4.
■
Loosen the chuck jaws from the drill bit
.
Note:
Rotate chuck body in the direction of the arrow
marked
UNLOCK
to loosen chuck jaws.
■
Do not
use a wrench to tighten or loosen the chuck jaws.
■
Remove the drill bit from the chuck jaws.
OPERATION
2
2
16
Fig. 9
UNLOCK
(RELEASE)
LOCK
(TIGHTEN)
Fig. 10
22
18
16
20
