RIDGID R4251, Operator'S Manual

Page: 13 / 36

13
WORK CLAMP
See Figure 5
The Vertical Work Clamp secures the workpiece to the table to
provide more stability and keeps the workpiece from creeping
toward the saw blade.
To install the Vertical Work Clamp do the following:
1.
Place the Clamp Shaft (A) in either hole (B) on the Miter
Base.
2.
Slide the clamp arm so the pad touches the workpiece.
3.
Rotate the knob (C) clockwise to secure the workpiece.
To loosen, turn Counter Clock Wise.
DUST BAG
DUST PORT ATTACHMENT
See Figure 6.
The Tool includes a Dust Bag (PC4) that attaches over the
Exhaust Port on the Upper Blade Guard. Slide the Plastic Collar
onto the Dust Exhaust Port on the back of the Saw Head.
NOTE:
To remove the Dust Bag for emptying, simply reverse
the above procedure.
See Figure 7.
The tool includes a 2 1/2 inch Dust Port Adapter (PC9) that
attaches over the rear exhaust port on the Upper Blade Guard.
It can be used to connect your miter saw to a standard 2 1/2
inch vacuum or dust collection hose.
1.
The dust port adapter set-screw (F) should be aligned
with the label located on the dust port (E).
2.
Tighten the set-screw when aligned to the arrow found
on the label.
ASSEMBLY
Figure 5
Figure 6
Figure 7
A
B
D
PC4
C
E
F
PC9