12 – English
OPERATION
Press down on the nail stop tab near the end of the
magazine and slide the nails over the tab.
Remove the nail strip from the tool.
CLEARING A JAMMED FASTENER
See Figures 11 - 13, page 17.
WARNING:
Remove the battery pack and remove nails from
the tool before clearing a jammed fastener. Failure
to do so could result in serious personal injury.
If a jam occurs, the tool will automatically enter into a jam
mode and reset the driver blade. The tool LED, located on
the rear base of the nailer, will flash red. Remove the battery
pack. Check to ensure that the tool is free from a jammed
fastener. In the event of a severe jam the magazine may re-
quire removal to clear the jammed fastener before reinserting
the battery. The battery must be removed and reinstalled to
reset it into normal operation mode.
Remove the battery pack.
Remove fasteners from the tool.
Using the included hex key, loosen, but do not remove, the
two socket head cap screws at the front of the magazine
that mount it to the tool.
With the same hex key loosen the rear mounting socket
head cap screw two to three turns, but do not remove it.
Slide the magazine towards the rear of the tool. This
should expose the jammed fastener and allow for easy
clearing. If needed the magazine can be removed.
Remove the bent nail, using needle-nose pliers if
necessary.
NOTE:
If a jam is too severe and needle nose pliers can’t
remove the jammed fastener, the tool may need to be
serviced by an authorized service center.
Reverse steps to replace the magazine.
MAINTENANCE
WARNING:
When servicing use only identical replacement
parts. Use of any other parts may create a hazard
or cause product damage.
WARNING:
Always wear eye protection with side shields
marked to comply with ANSI Z87.1. Failure to do
so could result in objects being thrown into your
eyes resulting in possible serious injury.
WARNING:
Always remove battery pack from the tool when
you are assembling parts, making adjustments,
cleaning, or when not in use. Removing battery
pack will prevent accidental starting that could
cause serious personal injury.
GENERAL MAINTENANCE
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use. Use
clean cloths to remove dirt, dust, oil, grease, etc.
WARNING:
Do not at any time let brake fluids, gasoline,
petroleum-based products, penetrating oils, etc.,
come in contact with plastic parts. Chemicals can
damage, weaken or destroy plastic which may
result in serious personal injury.