10
1. Remove the air compressor from the
carton.
2. Place the compressor on a secure,
level, and stationary work surface and
look it over carefully.
3. Make sure the dipstick is in a plastic
bag secured to the pump.
4. The pump has been filled with the
appropriate amount of oil (250 mL /
8.4 oz) by the factory.
5. Replace the plug with the dipstick
located inside the bag. Check the oil
level using the dipstick.
6. If the oil level is below the “MIN” line,
fill the pump until the oil level reads
between “MIN” and “MAX” lines. (For
oil type and fill directions, see
“Lubrication” section in the manual)
Unpacking and Checking Contents
Do not operate unit if damaged
during shipping, handling or
use. Damage may result in
bursting and cause injury or
property damage.
!
WARNING:
For your own safety, never
operate unit until all assembly
steps are complete and until
you have read and understood
the entire operator’s manual.
!
WARNING:
To reduce the risk of injury, if
any parts are missing, do not
attempt to operate the air com-
pressor until the missing parts
are obtained and installed cor-
rectly.
!
WARNING:
1. Check and tighten all bolts, fittings,
etc., before operating compressor.
2. Make sure compressor is filled to
proper oil level before use.
3. Operate compressor in a ventilated
area so that compressor may be
properly cooled.
4. Compressor should be located where
it can be directly plugged into an out-
let. An extension cord should not be
used with this unit.
5. To avoid loss of power and overheat-
ing, additional air hose must be used
to reach work area instead of exten-
sion cords.
Installation
Summary of Contents for OL50135AL
Page 23: ...Notes 23...
