18
Locating Parts
1. From the bag labeled "Caster" remove only the follow-
ing hardware:
8
Hex Jam Nut, 3/8-16
4
3/8 Spring Lockwasher
8
Washer, 3/8 x 7/8 x 5/64
4
Foot Leveling
WARNING: If your saw has damaged or missing
parts, they must be repaired or replaced before
this assembly can be completed. Reference your
saw owner’s manual or Authorized Service Depart-
ment if necessary.
Assembly Hints:
• The swivel caster may be mounted on the left or right
side of the leg stand. See illustration.
• Make sure the leg and stiffener bolts are loose in order
to align the holes in the legs with the holes in the end
frames.
• All four connections to your leg stand are done the
same way, using the same hardware.
• It may be helpful to place the frame on blocks of wood
approximately 4" thick while assembling it to the leg
stand.
• Install frame assembly so warning label can be read
from outside the legs.
2. There are two holes in each end of the end frames.
Mount the casters through the holes which will be to
the outside of your leg stand. Use leveling feet, nuts,
lockwashers and washers as shown.
Assembling Universal Caster System To Saw
Nut Hex Jam
3/8-16
Washer
3/8 x 7/8 x 5/64"
Lockwasher
Spring 3/8
Leveling Foot
Swivel Caster
Wood
Lockwasher
Nut
Washer
Leveling
Foot
Nut
Washer
Block
Use Holes
On Outside
