04
STABILISERS
ALWAYS ENSURE STABILISER SIZE IS CORRECT AND ABLE TO SUPPORT TOWER
Lightly tighten the upper clamps above the sixth rung on each corner post. Position the lower clamp
above the bottom rung. Ensure the lower arm is as horizontal as possible. Position the stabilisers so that
the footpads are approximately equidistant from each other, as shown in Fig.2. Adjust the outrigger and
reposition the clamps as required to make firm contact with the ground. Ensure the clips with locking pin are
in place. When in the correct position, tighten the clamps firmly.
To position the tower against a wall, do not remove the stabiliser; move parallel with the wall. (Fig.3)
To position the tower in a corner, remove the inside stabiliser and place the outside two parallel with the wall.
(Fig.4)
Fig 2
Fig 3
Fig 4
Summary of Contents for Span 400
