RIDGE
ACCESSORIES
PAGE 9
FUNCTION- Channel Selection
SELECTING THE UHF CHANNEL
To select a channel, press the
“(MENU/PWR) BUTTON”
once, the channel number on the LCD
will start flashing. Press the
“UP ARROW”
or
“DOWN ARROW”
to scroll to the desired channel.
Once the desired channel has been selected, press the
“(MONI) BUTTON”
and this will save the
selected channel and the radio will return to the default screen with the new channel displayed.
For your reference a list of the available channels, corresponding frequencies and guidelines for
their use and selection can be found on page 15-16 of this instruction manual.
NOTE:
Channels 05 and 35 are reserved for emergency use only.
FUNCTION- CTCSS & DCS
WHAT IS CTCSS AND DCS?
CTCSS (Continuous Tone-Coded Squelch System) and DCS (Digitally Coded Squelch) modify
the transmission signal to allow multiple users to share the same channel without disturbing each
other. This is an important feature on a radio when there are many radio users in the same area.
CTCSS continuously superimposes any one of about 50 low-pitch audio tones on the transmitted
signal, ranging from 67 to 254 Hz.
DCS was designed as the digital replacement for CTCSS. DCS adds a 134.4 bps (sub-audible)
bit stream to the transmitted audio
CTCSS or DCS is enabled by on the radio through selectable sub channels. When CTCSS or
DCS is enabled, incoming signals must be on the same CTCSS or DCS sub channel as the
receiving radio or they will be filtered out.
NOTE:
The CTCSS and DCS Tone Charts can be found on page 17-19 of this instruction manual.
SETTING CTCSS AND DCS
Press the
“(MENU/PWR) BUTTON”
twice, the CTCSS/DCS channel number on the LCD will
start flashing.
To enable CTCSS, press the
“UP ARROW”
or
“DOWN ARROW”
until CTCSS appears on the
screen, channel selection can be made between 1-38. Once the desired setting is selected, press
the
“(MONI) BUTTON”
to save the setting. The unit will automatically change back to the default
screen with the CTCSS sub channel now on display.
To enable DCS, press the
“UP ARROW”
or
“DOWN ARROW”
until DCS appears on the screen,
channel selection can be made between 1-83. Once the desired setting is selected, press the
“(MONI) BUTTON”
to save the setting. The unit will automatically change back to the default
screen with the DCS sub channel now on display.
To turn off CTCSS and DCS, press the
“UP ARROW”
or
“DOWN ARROW”
until “00” appears.
Press the
“(MONI) BUTTON”
to save the setting. The unit will automatically
change back to the default screen and CTCSS/DCS will no longer be displayed.
Summary of Contents for RR10PK
